CJ19 AC Contactor (Also known as magnetic contactor) is mainly used for the power line of AC 50Hz or 60Hz, rated operating voltage of 400V, for putting into low-voltage reactive power compensation equipment into or cutting off low voltage parallel capacitor. The magnetic contactors have inrush current suppression device, magnetic contactor can effectively reduce the impact from closing inrush current for the capacitor and inhibit the over-voltage when making and breaking.

Common models:
CJ19-25/11 CJ19-32/11 CJ19-43/11 CJ19-63/21 CJ19-80/22 CJ19-95/22

Ambient air temperature: -5℃~+40℃, the average does not exceed +35℃ within 24 hours.
Altitude: not more than 2000m.
Atmospheric conditions: the maximum temperature is +40℃, the relative humidity is not more than 50%; at lower temperatures can allow a higher relative humidity, for example, +20℃ up to 90%, special measures should be taken for condensation produced occasionally due to temperature changes.
Pollution level: 3.
Installation category: Ⅲ.
Installation conditions: The inclination of the installation surface and the vertical plane is not more than ±5°.
Shock Vibration: The product should be installed and used in the place without significant shaking, shock and vibration.

1. CJ19 (CJ16) series magnetic contactor for the direct-acting double-break structure, the contact system is divided into two layers, the upper layer has inrush current suppression device composed of three pairs of current limiting contacts and current limiting resistance, when it closes, work contact connected before it connected for a few milliseconds, the permanent magnet in the current limiting contact releases via spring reaction force, breaks current limiting resistance, so that the capacitor work normally. Internal circuit connection diagram of contactor see Figure.
2. 12,18,20Kvar magnetic contactors have two pairs of auxiliary contacts, 30Kvar magnetic contactor has three pairs of auxiliary contacts.
3. Contactor terminals are covered with an insulating cover, safe and reliable. Coil terminals are marked with voltage data to prevent incorrect connections. 12,18,20Kvar magnetic contactor can be installed by screws, but also installed in the 35mm standard card rail of 35mm by the bottom of the slider buckle. There is a removable white rectangular card on the mask that allows the user to print the item code.

CJ19-25~43 contactor has two pairs of auxiliary contacts.

CJ19-63~95 contactor has three pairs of auxiliary contacts.

CJ19-115~170 contactor comes with a pair of auxiliary contacts.Contactor terminals are covered with an insulating cover, safe and reliable. Coil terminals are marked with voltage data to prevent incorrect connections.

CJ19-25~43 contactor can be installed by screw, but also installed in the 35mm standard card rail by the bottom of the slider buckle.

CJ19-63~95 can be installed in the standard card rails of 35mm or 75mm.

CJ19-115~170 contactor can be installed with screws or two standard card rails of 35mm.

The series contactors except for screw installation, can also use standard card rail fast-way embedded mode for installation. For CJ19-25, 32,43 contactors, the width of the card rail is 35mm, for CJ19-63,80,95 contactor, the width of the card rail is 35mm or 75mm. If you would like to know more about the CJ19 capacitor changeover contactor , such as instruction manual, price, maintenance and other information, please contact us.

Keywords: CJ19, magnetic contactor，Din Rail Mounted Contactor